How to Fix a Dead Kia Picanto Key Fob

The Kia Picanto is a city car that can swerve through traffic gaps and width limitations as if they weren’t there. It’s a small car that comes with many features.

There are kia car key replacement why the key fob that you have on your Kia Picanto could not work. The most common reason is the battery is dead.

Dead Coin Battery

A dead battery is the most frequent reason of a Kia Picanto’s key fob not working. Usually, the key fob will show warning signs prior to dying in a way, like losing range or showing erratic behavior. If you notice any of these warning indications, it is recommended to replace the battery before it completely fails. Choose a replacement battery that has the same voltage, size, and specification as the original.

If the key fob isn’t working, it may be time to visit a dealership to get a replacement. This is the only way to ensure the replacement will be programmed correctly and compatible with your car. If you attempt to reprogram an ignition key fob without following the proper procedure could damage the chip inside and result in it not functioning.

Another possibility is that the receiver module has developed an issue. This could be caused by a chip that has been damaged or wear and tear. The signs of this issue can be difficult to spot but it’s important to find out the cause as soon as you can. If you’re not able to use your key fob to lock or unlock your doors, or even if the spare key isn’t working and you are unable to lock or unlock the doors, call a dealership or a service center to get help. They’ll be able to diagnose the problem and repair it for you.

Faulty Chip

The key fob is equipped with the chip that sends a signal to a computer within the car. If the chip becomes corrupted and the code cannot be properly transmitted and the immobilizer will activate. This can be caused by various reasons. One of them is a low battery in the key fob. Water damage is another possibility. It is probable that the fob will stop working when it is wet.

A faulty chip could also be the reason the Picanto fob isn’t turning on the engine. If you’ve replaced the battery, reprogrammed the fob, but it still does not work the circuit board may be damaged. If this is the case, you will have to replace it.

To open the Fob you will need to press on a button that is located on the side of the fob. Once this is done you’ll be able to remove the mechanical key. The video below will demonstrate how to replace the battery on the key fob. Be sure to use a new battery that is the same size and voltage. The Fob could be damaged if used with the wrong type battery. Press the lock button after replacing the battery. If it works, then you have a good Fob.

Faulty Receiver Module

Your key fob is subject to lots of abuse and isn’t impervious to destruction. Over time, the batteries’ contacts and buttons could be damaged and stop working properly. It’s simple to fix the problem with a couple of tools.

To function, the fob needs to send a signal through a receiver inside your car. If the module is not functioning properly the fob won’t be able of opening or starting your vehicle. Resetting the fob is the first step you should try.

This is usually accomplished by disconnecting the 12 volt battery from the fob and allowing it to drain completely. Connect the negative and positive cables by reversing their order.

If the battery is in good condition and the fob doesn’t have any water damage, the problem could be due to the signal. This can be caused by several things like interference from nearby transmitters or objects that use the same frequency band as your Picanto’s receiver.

Key fobs are sealed with rubber that prevent the chip from getting wet. However should they be submerged in water, the chip could be destroyed. It’s essential to keep your key fob clear of the water and only use key fobs that have waterproof designs.

Faulty programming

Kia Picanto’s key fob makes it easy to start and unlock your vehicle. You can also use it to control your vehicle’s features. It is important to know how to use the key fob correctly especially in adverse weather conditions or if you have limited mobility. There are many Kia Picanto key tricks that will help you.

If your key fob suddenly stopped functioning it could be due to an issue with the internal chip. This is a rare occurrence however it could happen. It is recommended to visit a Kia dealer to determine the problem.

If you want to, you can attempt to reset your Picanto key fob. It’s a simple process and can be completed at home. The first step is to remove the key fob from the ignition switch. Then, connect the diagnostic tool to the OBDII port under the dash, and turn on the engine. The diagnostic tool will seek out details about your Picanto. This includes the manufacturer, model, and VIN.

You can also examine the battery for a dead coin battery. The retaining clips made of metal inside the key fob are designed to hold the battery in place and complete the circuit. If the retaining clips are not in good condition, they could interrupt the flow of electricity and cause a loss of function.